A transmission line is a connector which transmits energy from one point to another. The study of transmission line theory is helpful in the effective usage of power and equipment.

There are basically four types of transmission lines −

• Two-wire parallel transmission lines
• Coaxial lines
• Strip type substrate transmission lines
• Waveguides

While transmitting or while receiving, the energy transfer has to be done effectively, without the wastage of power. To achieve this, there are certain important parameters which has to be considered.

 

Main Parameters of a Transmission Line

The important parameters of a transmission line are resistance, inductance, capacitance and conductance.

Resistance and inductance together are called as transmission line impedance.

Capacitance and conductance together are called as admittance.

Resistance

The resistance offered by the material out of which the transmission lines are made, will be of considerable amount, especially for shorter lines. As the line current increases, the ohmic loss  also increases.

The resistance RR of a conductor of length “ll“ and cross-section “aa“ is represented as

Where

�ρρ = resistivity of the conductor material, which is constant.

Temperature and the frequency of the current are the main factors that affect the resistance of a line. The resistance of a conductor varies linearly with the change in temperature. Whereas, if the frequency of the current increases, the current density towards the surface of the conductor also increases. Otherwise, the current density towards the center of the conductor increases.

This means, more the current flows towards the surface of the conductor, it flows less towards the center, which is known as the Skin Effect.

 

Inductance

In an AC transmission line, the current flows sinusoidally. This current induces a magnetic field perpendicular to the electric field, which also varies sinusoidally. This is well known as Faraday’s law. The fields are depicted in the following figure.

This varying magnetic field induces some EMF into the conductor. Now this induced voltage or EMF flows in the opposite direction to the current flowing initially. This EMF flowing in the opposite direction is equivalently shown by a parameter known as Inductance, which is the property to oppose the shift in the current.

It is denoted by “L“. The unit of measurement is “Henry(H)“.

 

Conductance

There will be a leakage current between the transmission line and the ground, and also between the phase conductors. This small amount of leakage current generally flows through the surface of the insulator. Inverse of this leakage current is termed as Conductance. It is denoted by “G“.

The flow of line current is associated with inductance and the voltage difference between the two points is associated with capacitance. Inductance is associated with the magnetic field, while capacitance is associated with the electric field.

 

Capacitance

The voltage difference between the Phase conductors gives rise to an electric field between the conductors. The two conductors are just like parallel plates and the air in between them becomes dielectric. This pattern gives rise to the capacitance effect between the conductors.

 

Characteristic Impedance

If a uniform lossless transmission line is considered, for a wave travelling in one direction, the ratio of the amplitudes of voltage and current along that line, which has no reflections, is called as Characteristic impedance.

Where LL & CC are the inductance and capacitance per unit lengths.

 

Impedance Matching

To achieve maximum power transfer to the load, impedance matching has to be done. To achieve this impedance matching, the following conditions are to be met.

The resistance of the load should be equal to that of the source.

The reactance of the load should be equal to that of the source but opposite in sign.

Which means, if the source is inductive, the load should be capacitive and vice versa.